Eversense Review

IMG_1479

It has been nearly three months since I had my Eversense insertion. I first heard about the system at the ATTD conference in Paris and was instantly fascinated by the duration of the sensor (90 days), the insertion process as well as being able to monitor the CGM (Continuous Glucose Monitor) curves on my smartphone. Although I was super nervous before I had the little surgery, I was even more excited about trying out the new system.

So here are some short facts about the Eversense System:

  • implantable sensor
  • lasts up to 90 days (under the skin)
  • smartphone app with real-time tracking
  • on-body vibration alerts (via the transmitter) when your blood sugar is low or high
  • chargeable, removable, water-resistant transmitter

 

The implantation

The implantation process of the sensor took about 10 minutes. First, I had to decide on where I wanted to wear my transmitter so that my doctor could find the right spot to implant the sensor. Afterwards, the IMG_1550place got marked and disinfected.

After that, my doctor did a local anaesthesia with zig zag incisions. We had to wait a few minutes until it started taking effect so that they could start doing the 5 to 8 mm incision in my upper arm. The sensor then got inserted with a custom inserter. Afterwards, Steri-Strips were used to close the incision.

 

 

The transmitter

The Transmitter is worn over the sensor and wirelessly powers it to activate the transfer of glucose IMG_1281measurements. After implanting the sensor, the transmitter starts receiving glucose data from it and calculates the glucose value which is then sent to the Eversense App via Bluetooth. Even if you do not have your phone nearby, the sensor automatically receives the data every 5 minutes.

What I really like about the transmitter is its sleek and slim design as well as the on-body vibration alerts when your blood sugar is low or high. Those alarms are really helpful because I do not have to look on my phone to see what my blood sugar diva is doing at the moment.

One of the biggest challenges for me during the first two weeks after the implantation was the correct placement of the transmitter. To place the transmitter correctly over the sensor, you have to use the “Placement Guide” on the App so that you can see if the connection is good enough. However after using the CGM system for quite a while now, placing the transmitter correctly got very easy. 😉

 

IMG_0750My experience

So after wearing the Eversense system for more than 2 months now I have to say, I really like it. There are a few things that need improvement such as the transmitter’s battery capacity and the sensor duration.

I also didn’t have any problems with my skin compatibility while wearing the tape on which the transmitter gets placed.

What I enjoy most about the Eversense CGM is, that I don’t have to think about changing the sensor weekly or having to carry around tapes, an inserter, disinfectant and all the plastic packaging. And of course – no more ripping out the sensor! Which is one of the biggest advantages for me, since I have a special talent for ripping it out whenever I’m passing a door frame 😉

All in all I really enjoyed using the Eversense System. Monitoring my CGM curves on my smartphone really helps me in my daily life with T1D because it makes keeping an eye on my blood sugar diva so much easier.  :-)

 

 

 

 

IMG_0751 IMG_0749 IMG_0748

Leave a Reply